Resources

Built-up roof (BUR) membranes

Built up roof membranes, referred to by the acronym BUR, have been in use in the U.S. for more than 100 years. These roof systems are commonly referred to as "tar and gravel" roofs. BUR systems generally are composed of alternating layers of bitumen and reinforcing fabrics that create a finished membrane. The number of plies in a cross section is the number of plies on a roof: The term "four plies" denotes a four ply roof membrane construction. Sometimes, a base sheet, used as the bottommost ply, is mechanically fastened. Built up roofs generally are considered to be fully adhered if applied directly to roof decks or insulation.

The reinforcing fabrics also are called roofing felts or ply sheets. Roofing felts are reinforced with either glass-fiber mats or organic mats. Felts are produced in a standard width of 36 inches and metric width of about one meter.

The bitumen typically used in BUR roof systems is asphalt, coal tar or cold-applied adhesive. The asphalt or coal tar is heated in a kettle or tanker and then applied by mop or mechanical spreader. Asphalt is a petroleum product refined from crude oil; coal tar is derived from the distillation of coal. Cold-applied adhesives typically are solvent-based asphalts that don't have to be heated in a kettle or tanker.

Surfacing’s for built up roof systems include aggregate (such as gravel, slag or mineral granules), glass-fiber or mineral surfaced cap sheets, hot asphalt mopped over the entire surface, aluminum coatings or elastomeric coatings.

A roof system composed of a built up roof membrane with two or three plies and a polymer-modified bitumen membrane cap sheet is commonly referred to as "hybrid" system. NRCA considers this type to be a polymer modified bitumen membrane system.

Material standards

NRCA does not make any recommendations about which product or manufacturer to use; however, NRCA does recommend that bitumen’s, felts and mats used for BUR systems meet standards established by ASTM International.

The following commonly referenced ASTM International standards apply to materials used in the construction of BUR systems:

  • ASTM D312, "Standard Specification for Asphalt Used in Roofing"

  • ASTM D450, "Standard Specification for Coal Tar Pitch Used in Roofing, Damp proofing and Waterproofing"

  • ASTM D1863, "Standard Specification for Mineral Aggregate Used on Built Up Roofs"

  • ASTM D2178, "Standard Specification for Asphalt Glass Felt Used in Roofing and Waterproofing"

  • ASTM D2824, "Standard Specification for Aluminum Pigmented Asphalt Roof Coatings, Nonfibered, Asbestos Fibered, and Fibered without Asbestos"

  • ASTM D3909, "Standard Specification for Asphalt Roll Roofing (Glass Felt) Surfaced With Mineral Granules"

  • ASTM D4601, "Standard Specification for Asphalt Coated Glass Fiber Base Sheet Used in Roofing"

  • ASTM D4990, "Standard Specification for Coal Tar Glass Felt Used in Roofing and Waterproofing"

     

    Warranties

When purchasing a new roof system, there will be two warranties to consider. First, there will be the manufacturer's warranty. In general, these warranties cover defects in the manufacture of the roof membrane, and vary greatly depending up the specific material and products chosen. The Second is the Workmanship. At DC Contractors, we provide a 3 year warranty covering all workmanship unless otherwise specified for your particular project.

Article Categories

Choosing A Roofing Contractor

Educational

Low Slope Roofing

Roof Types

Steep Slope Roofing

advantage pic 4
Call Today 940.320.9520
advantage pic 5
6101 Long Prairie Rd., Ste. #744, #150
Flower Mound, Texas 75028